BAKFlip MX4 Hard Folding Truck Bed Tonneau Cover for 2004-2014 Ford F-150 5'6" Bed (66") | Durable Aluminum Construction | Weatherproof & Secure Cargo Protection | Perfect for Hauling, Camping & Outdoor Adventures

I previously had a L**d tonneau, soft roll up, held down by velcro strips down the sides. I spent about $300-$400 for it. After the first year, and some shrinkage, it never really fit right. This one fits perfect. I love the multi points of cable release as you unfold the tonneau. Also, I no longer am required to stand at the back of the bed of the truck to pull on cables on both sides of the roll up tonneau to release the latches. I can stand on one side or the other of the tonneau and it releases both sides. Fold up is easy, however, with each fold you are not lifting more weight than the previous fold. By the time you are lifting the last fold it is a little awkward. I love the matte finish and looks very sleek overall on the bed of the truck. Much better than the roll up that sat about an inch above the level of the bed of the truck. Set up was ok, I took my time over about 90 minutes, distractions in-between, but if I had focused I am guessing I could have set the entire thing up in 20-30 minutes. There were a couple spots on instructions where they were not clear, however, the pics helped. One thing I wish they had provided were plugs to place in the holes at the front of the tonneau. I know they provide the tubes to help drain, however, my truck has a spray in bed liner, sealing the spots where you can pop out the plastic bed plugs and run your drain tube out. They recommend drilling a hole to place the end of the tube, but I would prefer to plug the holes of the tonneau and just let the rain or snow drain off on its own. I wasn't sure about the rubber seal around the edges as there were a couple points in which there were waives or bumps and it did not look like it was going to seal properly. They recommend getting out a blow dryer to heat up the rubber seal and it would eventually lay flat. They also recommended you could let is sit in the heat of the sun. I decided to do the latter. Within a few hours the rubber seal laid flat and smooth against the truck bed. Overall, I am very pleased with the product. Is it worth over $1000 you pay, that is up to you to decide. I don't believe it is. When I compare to others, roll up or hard flip tonneau, considering the latches and other aspects, I think it is more like a $650-$800 product, but no where near $1000.Super easy to install and looks amazing. Title and description could be better. It says for older F150 with 5' 6" bed, but listing shows photos of newer model F150 and only allows 5' 7" as smallest option. Listing could also mention about bull ring (stake pockets) fitment. Photos show that this cover works perfect with bull rings. Very happy with purchase.The cover came in and the box was sitting up ok one end. The cover itself was fine. The two plastic corner pieces were broken. I emailed BAK and installed the cover. They quickly responded and asked for my address. Two days later, I had new end pieces but for a different model cover. Emailed them again, they expressed shipped the correct ends. Installed new corner pieces and cover is doing fine. One person can install it, 2 just speeds it up on holding and tightening. It lines up pretty easy and is not hard to put on. I added some foam weather stripping to the tailgate area, of my truck, to help move water away from going in the bed. So far, that has helped the cover be 99.5% water proof. Very little water gets into the bed now. I would trust my luggage in the back, even while driving, during a storm. The cover locks in place but is easy to unlock and fold up. I only loose about 6" of bed space with the cover folded up to the cab. This could be handy on day, with having the short bed on a crew cab F150. The only issue I have seen with the cover is the plastic end pieces. They do feel flimsy. I shouldn't be doing anything to mess them up but you never know. The BAK customer service was on top of my issue from shipping tho. I would recommend trying this cover is you are looking for one that can fold up to the cab, for maximum bed space without removing. The cover can be removed easily tho. Two screw down knobs, on the inside of the cover, is all you have to take off to remove from the truck.Little expensive but you get what you pay for. Very little water gets in and its perfect to flip all the way up when you need to. Slim profile looks so much better than any of the covers that sit up higher than the bed.This is the second of these I've bought. I had one of my previous truck and loved it. With my new truck I looked at several other tonneau covers but I didn't like them as much as this one. The Bakflip lays flat and is secure. This one seems to install even easier than my first so I believe there have been some updates to the hardware since I bought my first one. No tonneau cover is going to be 100 percent watertight but I get very little water in this one. Unless I decide to go with a retractable in my next truck I will likely again go with this same one.Needed to do some trimming on the box liner but the fit is perfect! Very well made.parfaitement ajusté, très beau, facile a installé, très bon état malgré boite brise avec chariot élévateur !Great truck box cover, the fit is awesome!Top quality, easy to install, makes me feel like top ramenGood product